Skip to content
Call:1-888-551-3082 International: 1-919-443-0207 sales@servosupplier.com
Call:1-888-551-3082 International: 1-919-443-0207 sales@servosupplier.com
series image of PYRG015K1XXVP00

PYRG015K1XXVP00

by Sanyo Denki
$1,023.00 - $1,023.00
$1,023.00
$1,023.00 - $1,023.00
$1,023.00
Available, Shipping Varies
The PYRG015K1XXVP00 servo amplifier by Sanyo Denki is a high-quality device from their respected PY series. This amplifier operates with a 48/140VDC input voltage rating. Cooling periods after operation are crucial, due to the device's tendency to heat up. Parameter settings can be adjusted through PY PC-Setup software or a remote operator, excluding power phasing procedures. The amplifier utilizes a convection cooling mechanism and must be mounted upright with a 10mm separation on all sides. It should be used in non-explosive, non-corrosive, and non-combustible surroundings. The amplifier operates within a non-working temperature range of -20°C to +65°C, pairing optimally with Sanyo Denki's P series servo motors. It boasts two single-phase control circuit power terminals, offering a 200VDC to 230VDC power supply. After connecting the device, a check is necessary to confirm the control signal voltages and the bus voltage are within the acceptable range. The control and command input wires should have minimal length, with thresholds of 50m and 3m respectively. The amplifier showcases two LEDs that indicate the presence of a +5V control power supply and charged bus capacitors, which might signify high voltage.
30 Day Warranty
Technical Specifications
  • Manufacturer: Sanyo Denki
  • Product Model: PYRG015K1XXVP00
  • Type: Servo Amplifier
  • Power: 48/140VDC Input Voltage Rating
  • Software: PY PC-Setup
  • Installation Requirements: Must be mounted upright with at least 10mm space on each side
  • Ideal Environment: Non-explosive, non-combustible, and non-corrosive
  • Non-Operating Temperature Range: -20°C to +65°C
  • Compatible Products: Manufacturers P series of servo motors
  • Control Circuit Power Terminals: Two single-phase control circuit power terminals featuring 200VDC to 230VDC
  • Control Wires Length: Command input wire no more than 3m, all other control wires no more than 50m
  • LED Indicators: Presence of a +5V control power supply when power LED is on, bus capacitors charged when control LED is on
  • Time Delay: 300ms when amplifier is in position mode

Get In Contact

Email: sales@servosupplier.com


Phone Number: 1-888-551-3082


International: 1-919-443-0207

Fax: 1-919-867-6204