HDS02.2-W040N-HA17-01-FW
The HDS02.2-W040N-HA17-01-FW is a drive controller produced for the HDS Drive Controllers series. It forms part of a multi-axis rack and supplies regulated power so machine tools, printing lines, and handling robots can follow coordinated motion commands from a PLC. In this role, it serves as the power stage for servo axes that require stable torque and speed control during continuous industrial operation. The controller is intended for systems where power conversion is handled inside the rack while higher-level motion logic remains elsewhere in the machine.
This unit delivers a rated output current of 40 A, indicating the maximum continuous phase current the power stage can provide without derating. This rating applies to continuous operation rather than short peak demand. Command values enter the drive over an analog interface, so torque or velocity references are transmitted as voltage signals and processed by the internal control loop. Thermal management is handled by a built-in internal air blower, which moves cabinet air through the heat sink to maintain safe semiconductor temperatures. The controller belongs to the DIAX04 family, so it shares mechanical dimensions and rack interfaces with other modules in that platform. Within that system, the unit is part of Line 02.
The unit is hardware version 2, which places it in the later revision for this design line. As an HDS Drive Controller, it occupies the power slot of a multi-axis rack while higher-level control remains in the digital master. Built by Bosch Rexroth Indramat, the module is part of the HDS Drive Controllers series and uses the same mounting rails, DC bus bars, and fault signaling scheme found across the platform. It also follows the common electrical layout of the platform, which supports consistent wiring with compatible motors, feedback cabling, and neighboring rack modules during installation.
