HDS03.1-W075N-HS22-01-FW
The HDS03.1-W075N-HS22-01-FW is a modular drive controller used in multi-axis motion platforms in the HDS Drive Controllers series. It operates as a secondary axis unit that works with other DIAX04 components through the fiber-optic command bus. In operation, the controller receives velocity and torque commands, converts them into regulated three-phase output, and monitors motor feedback to maintain closed-loop control. This operating method supports coordinated motion where accurate response and stable axis regulation are required throughout the machine cycle.
The unit provides a continuous output current of 75 A, allowing it to support demanding acceleration loads without triggering an overcurrent shutdown. Command and diagnostic data are exchanged over the SERCOS interface, which uses an optical network for deterministic timing and electrical isolation between the controller rack and surrounding machine electronics. Thermal management uses a built-in air blower, so cabinet air is drawn across the heat sink without external ducting. The controller is part of the DIAX04 family, which gives it compatible dimensions and connector placement with related modules in the same system. Functionally, it is an HDS Drive Controller that provides axis-specific power conversion and closed-loop regulation for synchronous and asynchronous motors.
The unit is part of Line 03, which places it in the third design line for this controller platform. It is marked as Version 1, indicating the initial version of this model within that design line. The housing follows the shared mounting profile used by matching modules, which helps it fit the same rack arrangement and connector spacing used across the platform. Its modular format also allows it to operate alongside compatible power supply and feedback components in the same drive system without changing the basic mechanical layout.
