HDS04.1-W200N-HA22-01-FW
The HDS04.1-W200N-HA22-01-FW is a drive controller developed by Bosch Rexroth Indramat. In a multi-axis DIAX system, this unit forms the power stage that converts motion commands into regulated current for servo motors. It supports coordinated control of position, speed, and torque in automated machinery and material-handling cells. The module is intended for applications that require a dedicated power stage between the control system and the motor. It is suited to axes that need stable current regulation during acceleration, deceleration, and steady-speed operation.
This controller exchanges setpoint and diagnostic data through an analog command communication interface, allowing straightforward integration with legacy CNCs and PLCs that use voltage or current reference signals. Thermal management is provided by a built-in internal air blower, which pulls cabinet air across the heat sink so the module can operate without external ducting. The unit belongs to the DIAX04 family, so it uses the same platform structure as matching supply and communication modules. Its power electronics are rated for a continuous output of 200 A, which allows the controller to drive medium-to-large synchronous or induction motors on presses, gantries, and transfer lines under normal ambient conditions. This current capacity supports demanding axis loads where sustained motor torque is required.
The designation Line 04 identifies the fourth design line, and Version 1 marks the first release for this hardware. The controller is part of the HDS Drive Controllers series, so its mechanical dimensions, connector layout, and safety circuitry match adjacent axes within the same platform. This common layout supports consistent cabinet wiring and use with related modules released for the same system. It also helps keep installation planning straightforward when several axes are grouped in one drive assembly.
