HDS05.2-W300N-HA17-01-FW
The HDS05.2-W300N-HA17-01-FW is a drive controller module produced by Bosch Rexroth Indramat and supplied within the HDS Drive Controllers series. Designed for cabinet mounting, the unit pairs with common DC-bus supplies to energize servo motor power stages in multi-axis machining centers, pick-and-place gantries, and packaging lines. In coordinated systems, it serves as the power stage between the supply module and the connected servo axis, supporting stable torque delivery and responsive speed control. It converts intermediate-circuit energy into synchronized three-phase outputs, supervises current and position loops, and exchanges status data with the plant PLC. Its modular housing slides into standard guide rails and locks through front connectors without disturbing the shared bus bars.
The command communication interface is analog, so ±10 V velocity or torque references can be sent directly from motion cards without fieldbus conversion. This makes the controller suitable for systems that use direct voltage-based setpoints instead of serial command channels. Its output bridge is rated for 300 A, allowing the module to deliver high current during acceleration while maintaining continuous operation at its nameplate value. Thermal management depends on a built-in internal air blower that forces air along the heat sink fins and directs exhaust toward the cabinet roof. The unit is part of Line 05 in this controller range.
The documented airflow pattern aligns with the DIAX04 family, so adjacent axes can share a common ventilation path without localized hot spots. The controller is Version 2, and it uses expanded diagnostic telegrams with parameter scaling that match the present current sensors. This helps keep reported operating data consistent when the unit is installed in existing racks. Cabinet ventilation openings should remain clear so the blower can move air freely across the heat sink and out of the enclosure.
