MDD065A-N-060-N2M-095GR1
The MDD065A-N-060-N2M-095GR1 belongs to the MDD Synchronous Motors series produced by Bosch Rexroth Indramat. It is a servo motor intended for use with compatible digital drive controllers, where it converts commanded current into precise rotary motion for positioning tables, pick-and-place axes, and similar automation stages. By pairing a compact 065 frame with an A-length housing, the unit offers a high speed-to-size ratio for installations that require a limited footprint but rapid shaft rotation. This motor is suited for automated axes that need repeatable motion over short cycle times.
Rated for a nominal speed of 6000 rpm, the motor can follow fast command changes without excessive overshoot when balanced to the standard grade. Continuous stall capability is 0.8 Nm, allowing it to hold loads during static process phases while staying within the thermal limits of the housing. Connections exit on the right side through a sealed connector, which helps simplify cable routing inside compact machine frames. Position feedback is supplied by an integrated multi-turn absolute encoder, so the controller knows rotor position after power loss. A plain shaft mates directly to couplings or pulleys, and alignment in mounting fixtures is aided by the 95 mm centering diameter. Because the encoder is built into the motor, no external position transducer is needed for closed-loop operation.
For load holding, a blocking brake delivers 3.0 Nm of static torque and is released electrically when motion is requested. Signal integrity between the feedback device and the drive is maintained through Digital servo feedback (DSF), which supports high-resolution velocity control at the controller. There is an internal shaft seal that limits lubricant migration along the shaft and helps protect internal components when properly installed. The motor uses a standard shaft end without a side-B extension, and it has standard dynamic balancing for stable rotation at high speed.
