MDD065A-N-060-N2M-095PA1
The MDD065A-N-060-N2M-095PA1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts regulated electrical power into mechanical rotation for axes that require fast speed changes and repeatable positioning in industrial automation lines such as pick-and-place stations, packaging tools, or small robotic joints. Its compact 065 frame and standard housing support installation on machine frames where space is limited. It is commonly used where compact servo axes must respond quickly to changing commands while maintaining consistent motion quality during repeated cycles.
The motor reaches a nominal speed of 6000 rpm, allowing high cycle rates when paired with drives that can supply the required frequency. At standstill, it generates 0.8 Nm of continuous torque, which is enough to hold light loads without overheating during dwell periods. A blocking brake integrated on the rear end supplies up to 3.0 Nm during power-off conditions, helping vertical or suspended axes remain in position. Mechanical alignment is supported by a centering diameter of 95 mm, which helps the motor seat accurately against mating flanges. Power and feedback conductors exit through a connector on side A, simplifying cable routing inside enclosures. The output shaft uses a keyway, providing positive torque transmission to pulleys or couplings without relying only on frictional clamping.
An integrated multiturn absolute encoder tracks position over multiple revolutions, and its data stream is transmitted to the controller through digital servo feedback for closed-loop velocity and position regulation. This feedback arrangement supports stable response during indexing, short moves, and repeated reversals. A shaft seal helps keep lubrication in and airborne contaminants out. Standard balancing keeps vibration low across the speed range, while the A-length stator and side A connection orientation make the motor suitable for compact gantry axes or indexing tables that need minimal overhang and simple cable routing.
