MDD065C-N-040-N2L-095PR1
Bosch Rexroth Indramat manufactures the MDD065C-N-040-N2L-095PR1 within its MDD Synchronous Motors series. This unit is classified as a motor for digital drive controllers and is installed in tightly regulated motion axes where electronic drives require precise torque feedback. It is intended for applications that depend on repeatable motion during frequent starts, stops, and speed changes. In automated production lines, the motor serves as the mechanical actuator that converts controlled electrical output from the drive into rotation for conveyors, pick-and-place arms, and process spindles.
The mechanical interface uses a centering diameter of 95 mm, along with a standard housing and standard balancing, so the rotor runs smoothly in compact frame assemblies. Frame designation 065 and motor length code C identify the envelope dimensions and active stack length used for this version. The motor reaches a nominal synchronous speed of 4000 rpm and delivers a continuous standstill torque of 2.1 Nm. Position and velocity data are returned through digital servo feedback so the controller can maintain accurate closed-loop motion. A keyed shaft end and connector-based power terminals support straightforward installation and repeatable orientation.
An integrated holding brake provides 3.0 Nm of static torque to secure the load when the axis is de-energized. The motor also includes a shaft seal, which helps protect the internal bearings from lubricant washout and airborne contaminants. All power and signal conductors exit on the right side through a single connector, which helps keep cable routing orderly in dense cabinets. The shaft is provided only on the drive side, while side B remains closed, and the keyway mates with standard hubs. This arrangement keeps the non-drive end compact and leaves the output interface dedicated to the driven machine element.
