MDD065D-N-040-N2M-095GL1
The MDD065D-N-040-N2M-095GL1 is a synchronous servo motor produced by Bosch Rexroth Indramat and supplied within the MDD Synchronous Motors series. It is intended for use with digital drive controllers where precise speed regulation and position control are required on packaging lines, pick-and-place axes, and small machining stations. Its synchronous motor design supports stable response during acceleration, indexing, and low-speed positioning. This makes the unit suitable for automated equipment that depends on repeatable motion and accurate feedback over changing load conditions.
The motor reaches a nominal speed of 4000 rpm, enabling rapid cycle execution while remaining within the thermal envelope of the D-length housing. At standstill, it can supply 2.7 Nm of continuous torque, which provides the force needed for holding loads or making slow, steady moves without overheating the windings. Position information is generated by an integrated multi-turn absolute encoder, so the drive can retain shaft position information over multiple revolutions after a power interruption. Power and feedback wiring are routed through connection hardware on the left side, which can simplify cable routing when the cabinet layout favors that direction. Mechanical alignment is aided by a centering pilot of 95 mm, helping the motor register concentrically with connected gearboxes or machine fixtures.
A blocking brake provides 3.0 Nm of static torque to lock the rotor whenever the drive is disabled, which helps prevent drift on vertical or suspended axes. Command and feedback loops use digital servo feedback, allowing the controller to process accurate position and velocity data during closed-loop operation. The output uses a plain shaft, so couplings or pulleys can be clamped directly without a keyway. A fitted shaft seal limits dust and coolant ingress at the output end, supporting use in typical industrial environments where splash protection and clean internal bearing conditions are important.
