MDD071A-N-060-N2S-095GL0
The MDD071A-N-060-N2S-095GL0 is a three-phase permanent-magnet synchronous motor produced by Bosch Rexroth Indramat for integration with drive controllers in the MDD Synchronous Motors series. As a purpose-built servo element, the unit converts commanded current into precise rotary motion, enabling position and velocity control on packaging lines, assembly stations, and handling axes in industrial automation. It is intended for use with compatible servo controllers that regulate current, speed, and position in coordinated machine axes. With its compact flange and high-speed capability, it suits applications that require rapid indexing and narrow mounting envelopes. The motor is appropriate for compact machines where repeatable motion and fast response are required.
A nominal speed of 6000 rpm allows high surface speeds on compact tooling and sets the electrical frequency range the inverter must supply. The continuous standstill torque of 2.2 Nm is the sustained torque available for holding and low-speed tasks without overheating. Position data are returned through digital servo feedback, enabling high-resolution closed-loop control without external encoders. This feedback lets the drive monitor rotor position continuously during acceleration, deceleration, and steady-state operation. The motor has a 95 mm centering diameter that aligns the stator to the machine frame, and all power and feedback plugs are oriented to the left side to simplify cable routing in tight cabinets.
In installation, the rotor is supplied with standard balancing, so coupling components can be mounted without added correction weights. Electrical terminations are made through a single connector that carries phase, sensor, and ground conductors, which reduces the number of separate cable entry points at the motor. The output side uses a plain shaft with a shaft seal to help block lubricant ingress during continuous operation. The motor is supplied without a blocking brake, so static holding must come from the drive or external clamps. Frame coding 071 and length class A allow the unit to fit close to adjacent axes inside compact multi-motor cells.
