MHD093B-024
The MHD093B-024 is an AC servo motor in the MHD Synchronous Motors series from Bosch Rexroth Indramat. In automated equipment, it converts controlled current from a matching drive into precise shaft rotation for positioning and speed control. This type of motor is commonly used on packaging systems, gantry axes, and machine tools where repeatable motion is required through frequent duty cycles. Its synchronous design allows the connected drive to regulate torque and speed with quick response during indexing, contouring, and steady-state operation. That behavior helps moving axes start, stop, and reverse cleanly under changing loads.
A centering diameter of 130 mm fits into a pilot recess and helps keep the motor aligned during installation. The flange size is 140 / 150 mm, which supports mounting on machine faces that use either bolt pattern. Under continuous stall conditions, the motor can deliver 17.5 Nm of torque without exceeding its thermal limit. That output is useful for low-speed feed axes and other duties where steady torque is needed at little or no shaft rotation. Housing length code B places the unit in the mid-length version of this frame, while motor size 093 places it in the corresponding mechanical envelope used for this motor platform.
Drive controllers recognize winding code 024, which matches the electrical data used for commutation and current control. The motor also uses embedded temperature sensors so the drive can monitor winding heat during demanding operation and react before excess temperature builds. The unit is classified as a Servo Motor, which means it is intended for closed-loop motion tasks that require controlled speed and position rather than simple open-loop rotation. This arrangement suits transfer systems and similar automated axes that must maintain accuracy through repeated starts, stops, and load changes. It also supports stable operation where the drive must respond quickly to changing motion commands.
