Skip to content
Call:1-888-551-3082 International: 1-919-443-0207 sales@servosupplier.com
Call:1-888-551-3082 International: 1-919-443-0207 sales@servosupplier.com
series image of AKM42G-EKC2C-00

AKM42G-EKC2C-00

by Kollmorgen
$3,937.50 - $3,937.50
$3,937.50
$3,937.50 - $3,937.50
$3,937.50
In Stock, Ships 3 - 5 Days
The AKM42G-EKC2C-00 is a synchronous servomotor produced by Kollmorgen, intended to be used with a SERVOSTAR digital servo amplifier to form a digital control system. It features ten pole pairs, and complies with the 3K3 climatic category as per EN 50178 specifications. The motor contains an electrically isolated thermistor and carries a torque constant of 0.74 Nm/A. It can bear a radial load of 450 N at the shaft end. Certain safety measures should be considered while handling this unit; it might retain live power supply even when motionless, connectors should not be detached during operation, and formation of any liquid around the shaft in an IM V3 installation setup should be avoided. It can be installed at a maximum altitude of 1000 m. Lastly, the product possesses a holding brake designed for standstill incidents, and is not meant for constant operational braking.
30 Day Warranty
Technical Specifications
  • Manufacturer: Kollmorgen
  • Product Type: synchronous servomotor
  • Model: AKM42G-EKC2C-00
  • Pole Pairs: 10
  • Climatic Category: 3K3 (as per EN 50178 specifications)
  • Thermistor: Electrically Isolated in windings
  • Torque Constant: 0.74 Nm/A
  • Radial Load: 450 N at the shaft end
  • Motor Cable: Shielded 4 x 1.5 motor cable
  • Power Connections: Remain live even when not rotating
  • Safety: No assurance without low-resistance earth connection
  • Vulnerable Parts: Shaft and flange
  • Mounting Rule: No liquid accumulation around the shaft with IM V3 mounting
  • Installation Altitude: Up to 1000 m over sea level
  • Overload Protection: Not protected against heavy overload or short by the thermostat
  • Holding Brake: Standstill brake, not recommended for repeated operational braking
  • Control Loop: Closed torque or speed control loop with the SERVOSTAR servo amplifier
  • Assembly and Wiring: Should be done by personnel qualified in mechanical and electrical engineering
  • Motor Lead Connections: Must be connected close to the servo amplifier
  • Cable Selection: Adherence to EN 60204 specifications
  • EMC Interference: Possibility if shielding is incorrectly installed.

Get In Contact

Email: sales@servosupplier.com


Phone Number: 1-888-551-3082


International: 1-919-443-0207

Fax: 1-919-867-6204